Tool checklist
- Host machine with an RDMA-capable network adapter
- Secondary machine: data receiving and software installation
- Fusion hub
- Keyboard & mouse controller
- Bundled software and cables
Steps
- 1
Install the dedicated NIC driver
Install the Nynov-supplied driver onto an RDMA-capable adapter, then confirm the device reports a healthy status in Device Manager.
- 2
Secondary machine client setup and speed test
Install the companion client on the secondary machine, connect to Nynov RDMA with the Nynov key, and run the speed-test self-check to confirm the link is up.
- 3
Calibration and acceptance
Calibrate parameters per the edition-specific guide, run the acceptance script, and archive the report. Steps differ by license edition — always follow the guide matching your edition.
Notes / safety
Steps differ by license edition — follow the guide that matches your purchase. Always back up original firmware before writing.
FAQ / Troubleshooting
| Problem | Cause | Fix |
|---|---|---|
| Adapter not detected in Device Manager | The system was not set up as required. | Reinstall the driver as administrator and verify the signature policy is enabled. |
| Self-test times out, link not established | Port/cable spec mismatch or IP subnet conflict. | Swap in a compliant cable, verify IP configuration on both ends, then re-run the self-test. |
| Capture drops after long runs | The router is under-specced. | Replace the router with a Xiaomi AX3000 or higher-spec model. |